Picked this up on Craigslist
Dynamo Bar Table Non Coin Operated model pre-1993
670 pounds, slate top, all plywood construction

You can lift a truck with this oldschool bumper jack so why not 300 pound peice of slate .....

wood horse shoe lift point ..........

Got alot of new parts in
pocket liners, pocket gullies, new chrome feet, rubber cushions, one new chrome corner and new felt
slate is raised up and setting on a peice of schedule 40 pipe and some 2x4`s

What`s this it had a filler in it to make it a coin operated model ..... so guess I can fabricate it into one ..

planned on redoing the formica anyhow .....

found serial number .......

new Nevermar laminate, but too cold latley to glue it on .... black on rails and a burl woodgrain on the sides.

chrome dual exhaust

new chrome corner castings as well as chrome vinyl wrapped cabinet corners

used chrome plug buttons for markers ... inlaid in new formica rails

on it`s way to being a coin op table ......

refelt done ......... also got the legs repainted satin black and new chrome leg levelers ......

waiting on a coin chute to finish up the coin op install ...... next is slate install ,then new gulleys and pocket liners ......

slate back in

Ballview door made and coin door frame in ..........

just a little more chrome, duals and a hitch .........